| Tweet |
Custom Search
|
|
|
||
 LO 55-1905-222-12
NOTES:
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW -10 . Remove
F
lubricants prescribed in table 1 for temperatures above -10 . Lubricate with lubricants specified in table 2 for
F
temperatures below -10F.
2. WINCH. Remove inspection plate and remove oil level plug to check oil level. Add lubricant as required at fill to
bring up to level plug. Install oil level p lug and inspection cover.
3. BOW SHEAVE. Remove cover plate to lubricate: install cover plate.
4. RAMP SHEAVES. Lubricate through drain holes on underside of ramp. One fitting each sheave.
5. REVERSING MECHANISM LEVER ARM. Lubricate lever arm grease gittings, two places.
6. STEERING SYSTEM AND RAMP HOIST SYSTEM FILTERS.
a. Steering System filters must be changed when pressure drop across filter is 15 P.S.I. See note 7.
b. Ramp Hoist System filters must be changed when indicator reads in red. See note 8.
7. STEERING SYSTEM RESERVOIR AND STRAINER. When pressure drop across filter is 15 P.S.I., inspect reservoir
and strainers as specified in TM 55-1905-222-14.
8. RAMP HOIST SYSTEM STRAINER AND RESERVOIR. When filter indicator reads in red zone, inspect reservoir
and strainers as specified in TM 55-1905-22-14.
9. HYDRAULIC STARTING SYSTEM FILTERS.
CAUTION
Do not attempt to service filter element until system pressure has been relieved.
Service filter as specified in TM 55-1905-222-14.
10. STEERING CYLINDERS. Remove pin and lubricate pin sparingly and install pin.
11. STEERING TIE BAR. Remove pin and lubricate pin sparingly and install pin.
12. RAMP HOISTCABLE.
WARNING
When applying grease to wire rope by hand, broken strands of wire can cause injury to personnel. Use
approved gloves.
Apply grease evenly with small brush or by hand.
13. RAMP LOCKING MECHANISM. Grease every 50 hours, 3 grease fittings.
14. RAMP HINGE PINS. Lubricate hinge pins (6 places) with MPG grease.
15. RAMP HOIST HAND PUMP. Fill reservoir2/3 full.;
Card 5 of 8
|
||
|
||
