| Tweet |
Custom Search
|
|
|
||
 TB 600-1
PASS
FAIL
*10.
Start-Stop Switch. Do not hold start-stop switch in the start position longer than
15 seconds. Allow a starter cooling period of one minute before attempting to
restart.
____
____
*11.
Engine will not start. Repeats performance Step 9.
____
____
*12.
Engine Warm up. Allows engine three to fifteen minutes to warm up.
____
____
*13.
Circuit Breaker. Place circuit breaker in the ON position.
____
____
*14.
Operator/Crew Preventive Maintenance Checks and Service. Uses TM 5-6115-
332-14 and TM 5-2805-258-14 to perform during operation checks in sequence.
____
____
*15.
Frequency Meter. Insure frequency meter reads 60 or 400 hertz.
____
____
*16.
Voltmeter. 120/240 120/208. Rotate voltage selector to monitor the voltage of
each phase combination.
____
____
*17.
Ammeter. Rotate ammeter phase selector switch to monitor the load applied to
each phase. Not to exceed 100 percent.
____
____
*18.
Oil Pressure Gage. Insure oil pressure gage reads 20 to 60 psig.
____
____
*19.
Battery Charging Ammeter.
Should read zero or any reading on plus side of
scale.
____
____
*20.
Air Cleaner Restriction Indicator. Check indicator for red or green showing. If red,
contact organizational maintenance.
____
____
*21.
Engine. Inspect engine for loose or missing wiring parts and any oil or fuel leaks.
____
____
*22.
Oil Filter. Inspect for oil leaks.
____
____
*23.
Engine and Engine Accessories. The engine and engine accessories
that are hot should not be touched with the bare hands during operation or before they
have cooled sufficiently.
____
____
Change 3 H-36
|
||
|
||
