| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
2.
Disconnect windshield wiper electrical plug (1) from receptacle at center of control panel.
3.
Release six toggle fasteners (2) which secure cab to deck.
NOTE
Four fasteners are located outside on forward warning and two fasteners are located
inside cab rear port and starboard.
4.
Using four cab lifting handles (3) lift cab to clear engine, transmission and scoop controls. Remove cab from boat.
INSPECT:
Inspect rubber seal around cab enclosure for damage. If necessary remove existing rubber strip (4) and apply a 1-inch
strip of rubber (Item 20, App. C) with rubber adhesive (Item 21, App. C) to the cab mounting joint the total length of cab.
INSTALL:
1.
Position cab on boat using four lifting handles (3).
2.
Aline cab clamping fasteners (2) and close clamp fasteners (2).
3.
Connect windshield wiper electrical plug (1) to receptacle at center of control panel.
4.
Install searchlight (refer to paragraph 3-97).
3-14
|
||
|
||
