Custom Search
 
  
 
TM 5-1940-277-20
TM 1940-20/2
1.
Tag and disconnect electrical leads (1) from wiper motor at connectors (2).
2.
Loosen wiper motor holding bolt (3) using wrench.
3.
Slide wiper motor (4) from drive unit flange (5).
INSTALL:
1.
Position replacement motor (4) on windshield wiper drive unit flange (5) as shown in figure and aline drive mecha-
nism.
2.
Tighten motor holding bolt (3) using wrench.
3.
Connect electrical leads (1) to connectors (2).
NOTE
Do not run wiper on dry windows for more than one or two strokes. Wiper blades and/or
windshield may be damaged. Wet down windshield if further testing is needed.
3-18


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business