| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
INSTALL:
On new assembly loosen socket head screw (6) using Allen wrench.
1.
2.
Slide control lever off hub pin.
For transmission control head assembly, install detent plate (13) and secure with screws (12).
3.
Slide control lever back on hub pin.
4.
Install ball (16), spring (15) and screw (14) on control handle.
5.
Using flat tip right angle screw driver tighten screw (18) for friction adjustment.
6.
NOTE
Procedure applies to each control handle.
Move linkage plates (7) as required to allow clearance for cable pivots (8).
7.
NOTE
Use outer linkage holes for 2-3/4 inch travel.
8.
Insert cable pivots (8) in linkage plates (7).
Using Allen wrench tighten socket head setscrews (6).
9.
Using pliers place cotter pins (5) to secure cable pivots (8).
10.
11.
Flare ends of dotter pins (5).
12.
Place control head into console.
Using 9 mm open end wrench secure cables (10) to control head side plates (17) with cable damps (4).
13.
Using screwdriver and 3/8 inch open end wrench install four bolts (1), washers (3) and nuts (2) securing control head
14.
to console.
15.
Close access panel under console (refer to paragraph 3-154).
3-67
|
||
|
||
