| Tweet |
Custom Search
|
|
|
||
 TM 5-1940-277-20
TM 1940-20/2
INSTALL:
1.
Install end cap (15) on cable end (14).
2.
Install slide gear (12) onto cable end (14).
3.
Install cable bracket top and bottom (16).
4.
Using wrench install self-locking nut (13) securing slide gear (12) to cable end (14).
5.
Install gear slide casing (8) over gear slide (12) (gear teeth must be visible in casing slot).
Using two wrenches install two bolts (11). washers (10) and nuts (9) securing gear slide casing (8) to gear slide (12).
6.
7.
Install steering gear carriage (7) into console.
8.
Using two wrenches install four bolts (6) and nuts (5) securing steering gear carriage (7) to gear slide casing (8).
9.
Install steering support ring (4) in console. Using two wrenches install three bolts (3), washers (2) and nuts (1) secur-
ing steering support ring (4) to console.
Reinstall steering wheel assembly (refer to paragraph 3-44).
10.
11.
Reinstall cable stop (39) and tighten nuts (38) using two wrenches.
12.
Reinstall cable adjustment sleeve (35), insert (34), and bushing (33).
13.
Reinstall damp spacers (upper and lower section) (36) and, using screwdriver and 7/16 inch wrench, install damp
(28) and two bolts (27), two washers (26) and two nuts (25) securing damp to cable adjustment sleeve.
14.
Reinstall two bolts (24), two washers (23) and two nuts (22). Tighten using two 7/16 inch wrenches.
15.
Reinstall cable control yoke (32), bolt (31), washer (30) and nut (29). Tighten using 9/16 inch wrench and socket.
16.
Reinstall bolt (19), spacer (20), spacer (21), two washers (18) and nut (17) securing cable control yoke (32) to tierod
(40). Tighten using 9/16 inch wrench and socket.
17.
Reinstall port buoyancy flotation material (refer to paragraph 3-152).
18.
Reinstall aft cockpit (refer to paragraph 3-27).
19.
Close hydrojet hatches.
3-89
|
||
|
||
