| Tweet |
Custom Search
|
|
|
||
 TM 5-2010-205-14
Materials/Parts Required
Personnel Required
Front Seal P/N 7C6660
2 Persons
Rear Seal P/N 7W3200
INSPECT
1. Inspect front seal for cuts or damage.
2. Inspect rear seal for cuts or damage.
REPLACEMENT
1. Remove crankshaft rear seal (1) with puller assembly.
CAUTION
If crankshaft seal and wear sleeve come apart during installation, they
must be discarded and replaced with a new seal and sleeve assembly.
2. Clean crankshaft outside diameter and put sealing compound on surface.
3. Install locater (3) and bolts on rear of crankshaft.
4. Put wear sleeve and seal assembly (1) on locater with outside diameter bevel of wear sleeve toward outside.
5. Put installer (5) in position on locater.
6. Put lubricating oil on face of nut (4).
7. Install nut on locater.
8. Tighten nut until installer is at bottom.
9. After removing installation tools, check seal for correct position.
6-14
|
||
|
||
