| Tweet |
Custom Search
|
|
|
||
 TM 55-190-217-12
1. Idle speed adjusting
13. High speed spring
27. Weight housing cover
screw
retainer cover
28. Riser thrust bearing
2 High speed spring
14. Speed control lever
29. Governor riser
plunge
15. Throttle shaft lever
30. Weight housing
8. High speed spring
16. Cam
31. Weight carrier
4. Low speed spring seat
17. Fuel rod
82 Weight shaft assembly
5. Low speed spring cap
18. Locknut
33. Weight assembly
6. Low speed spring
19. Gap adjusting screw
34. Operating shaft fork
7. Buffer screw
20. Operating shaft bearing
36. Governor control housing
8. Locknut
21. Operating shaft
36. Operating shaft lever
9. Retainer locknut
22. Operating shaft busing
37. Differential lever
10. High speed spring
23. Gasket
38. Governor cover
retainer
24. Weight housing plug
39. Lockwasher
11. Locknut
25. Retaining bolt
40. Screw
12. Bolt
26. Shaft end bearing
Figure 4-20. Governor components.
(7) Tighten the governor-to-blower
bolts with
(9)
Connect the oil tube to the fitting on the
wrench J42/-2.
cover.
(8) Affix a new gasket to the weight housing
(10) Refer to figure 4-20 and position the fuel rod
cover. Place the cover in position and install four bolts
over the differential lever pin. Place a flat washer over the
with lockwashers.
pin and secure it with the retainer.
4-25
|
||
|
||
