| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-217-34
NOTE
Do not permit the outer end of the unit to tip down when being removed from the engine or
the clutch pilot bearing may be damaged.
Key to figure 3-43.
1. Lock washer
2. Driving ring bolt
3. Spring lock
4. Lock washer
5. Screw
6. Flexible tube assembly
7. Bolt
8. Lock washer
9. Lock plate
10. Retainer
11. Key
12. Clutch drive shaft
13. Key
14. Clutch release yoke
15. Grease fitting
16. Clutch housing
17. Gasket
18. Cover
19. Screw
20. Clutch hand lever
21. Bolt
22. Lock washer
23. Grease fitting
24. Nut
25. Bolt
26. Lock washer
27. Clutch release shaft
28. Woodruff key
29. Lockwasher
30. Bolt
31. Outer bearing assembly
32. Bearing cone
33. Bearing cup
34. Inner bearing assembly
35. Clutch release sleeve and collar
36. Pin
37. Link
38. Retaining ring
39. Bolt
40. Collar
41. Clutch release sleeve
42. Nut
43. Release lever spring
44. Adjusting ring wear plate
45. Adjusting ring
46. Inner pressure plate
47. Clutch facing
48. Pressure plate separator spring
49. Outer pressure plate
50. Retaining ring
51. Release lever
52. Pin
53. Clutch driving ring
54. Lockwasher
55. Nut
3-60
|
||
|
||
