| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNOR-MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-REASSEMBLY (Cont)
m. Control
1. If removed, place the
link
control link operat-
operating
ing lever on the bed
lever, and
of an arbor press,
needle
with a steel-support
under the bearing bore.
(87)
2. Lubricate the outer
surface of the bearing
with engine oil and
start the bearing,
numbered end up,
straight into the bore
of the lever. Insert
the pilot end of
installer in the
bearing and under the
ram of the press.
3. Then, press the bear-
ing into the lever
until it is flush with
the top surface of the
lever. Reverse the
lever on the press and
install the second
bearing in the same
manner.
n. Control
1. Lubricate the control
link
.
link operating lever
operating
needle bearings with
lever (87)
Shell Alvania No. 2
grease, or equivalent.
2. Place the lever in
position between the
two bosses inside the
governor housing.
3. Insert a flat washer
on each side of the
lever.
5-200
|
||
|
||
