| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNOR - MAINTENANCE INSTRUCTIONS
(Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-REASSEMBLY (Cont.)
c.
Key (41)
Install in center keyway
of shaft (38).
d. Spring
1. Place the spring lever
lever
assembly between the
assembly
bearing bores inside
(45)
the spring housing
with the arm (roller
end) of the lever
facing out.
2. Insert the correct end
of the speed control
lever shaft of the
spring housing, oppo-
site the bearing pre-
viously installed.
3. Align the key in the
shaft with the keyway
in the spring lever
and push the shaft
through the lever and
in the bearing until
the flat on the top of
the shaft is centered
under the set screw
hole in the lever.
e. Set screw
Thread the set screw into
(36)
the spring lever, making
sure the point of the
screw is seated in the
flat on the shaft.
f.
Needle
1. Place the second speed
bearing
control lever shaft
(40)
needle bearing,
numbered end up, over
the protruding end of
the shaft and start it
straight in the bore
of the housing.
5-212
|
||
|
||
