| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-8. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-DISASSEMBLY (Cont.)
j.
Rear end
1. Back out the center
Use two
plate
screws of pullers far
pullers J6270-1.
(57)
enough to permit the
flange of each puller
to lay flat on the face
of the end plate.
2. Align the holes in each
puller flange with the
tapped holes in the end
plate and secure the
pullers to the end plate
and secure the pullers
to the end plate with
six 1/4"-20 X 1-1/4" or
longer screws.
NOTE
Be sure that the 1/4"-20 screws are threaded all the way into the tapped holes in
the end plate to provide maximum anchorage for the pullers and to eliminate
possible damage to the end plate.
3. Turn the two puller screws
uniformly clockwise and
withdraw the end plate and
bearings from the blower
housing and rotors as shown
below.
5-230
|
||
|
||
