| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-10
5-64. SLACK PULLER AND MOTOR - ANCHOR WINCH - MAINTENANCE INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
REPAIR (Cont)
al. Port
1. Install in housing
plate
(86).
(85)
2. Push it over splined
end of shaft (96).
3. Do not damage pre-
formed packings
(89 and 90).
4. Allow dowel pin
(91) to engage in
proper hole.
am. Cam
1. Place on clean,
ring
flat surface.
(78),
rotor
2. Install spring
(84)
guides and vanes
springs
into rotor.
(82),
spring
3. Place ring compressor
guides
around the vanes and
(83),
tighten compressor
and
gradually until
vanes
springs and vanes are
(81)
in the position they
will occupy while in
the cam.
4. install the rotor in
the cam ring using a
back-up plate to pre-
vent the vanes from
sliding end-wise in
the slots and dam-
aging the springs.
5-800
|
||
|
||
