| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-11
5-71. .BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-ASSEMBLY (Cont)
4. Insert rotors
straight into the
housing and thru
the front blower
end plate.
5
Remove the oil seal
pilots from the
rotor shafts.
g
Blower
1. Install oil seal
rear
pilot J6270-5 over
end
the serrated end of
plate
each rotor shaft.
(46)
2
Check the dowel pins.
The dowel pins must
project .270" from
the flat inner face
of the rear end
plate to assure the
proper alignment of
the end plate with
the housing.
3. With the top of the
end plate identified
as in step 6a and
its flat finished
face towards the
blower housing,
slide the end plate
straight over the
oil seal pilots and
start the dowel pins
straight into the
dowel pin holes in
the housing. Then, n ,
push or tap the end
plate against the
housing .
5-996
|
||
|
||
