| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-11
5-77. FLYWHEEL AND HOUSING - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION
2.
Flywheel
a. Support the flywheel - ring gear
Ring
side up - on a solid flat surface.
Gear
b. Rest ring gear on a flat, metal
surface and heat the gear uniformly
with an acetylene torch, keeping
the torch moving around the gear
to avoid hot spots.
Do not, under any circumstances, heat the gear over
400 (204C), as excessive heat may destroy the
F
original heat treatment.
NOTE
Heat indicating "crayons", which are placed on the
ring gear and melt at a predetermined temperature,
may be obtained from most tool vendors. Use of these
" rayons" will ensure against over-heating the gear.
c
c.
Use a pair of tongs to place the
gear on the flywheel with the
chamfer facing the same direction
as on the gear just removed.
d. Tap the gear in place against the
shoulder on the flywheel. If the
gear cannot be tapped into place
readily, remove it and apply
additional heat, noting the above
caution.
5-1054
|
||
|
||
