| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-2
OPERATING INSTRUCTIONS FOR ANCHOR WINCH
PRESTART
1.
Cooling System
A.) Vent Air from circulating pump suction line.
B.) Check water level in #2 (port) main propulsion engine expansion tank.
START UP
1.
Check throttle clutch control, in neutral position.
2.
Start engine (refer to Operator's Manual).
A.) Observe lube oil pressure (Normal 40-55 PSIG)
B.) Observe cooling water temperature (Normal 175-185 degrees F.).
Maximum temperature 200 degrees,
allowable.
C.) Observe torque converter oil pressure (Normal 40-65 PSIG) and oil temperature (Normal 160-220 degrees F.-
Max. 250 degrees).
D.) Observe hydraulic control pressure (Minimum 350 PSIG-Normal 365-370 PSIG).
E.) Observe hydraulic operating pressure (Minimum 600-PSIG-Normal 600-800 PSIG).
3.
If lube oil pressure or cooling water high temperature, exceed Normals, stop engine by pulling emergency stop
located on control stand.
NORMAL SECURING OF STERN ANCHOR WINCH DIESEL ENGINE
1.
Stop engine at control stand or local control, after idling engine to cool down.
2-668
|
||
|
||
