| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-5
3-92.2. Flywheel Housing - Maintenance Instructions.
a. The flywheel housing is a one-piece casting, mounted against the rear cylinder block end plate, which
provides a cover for the gear train and the flywheel. It also serves as a support for the starting motor and the
b. The crankshaft rear oil seal, which is pressed into the housing, may be removed or installed without
removing the housing (paragraph 3-91).
This task covers:
a. Removal
b.
Inspection
c.
Installation
INITIAL SETUP :
Test Equipment
References
Concentricity Test
Overspeed Governor-Removed
Gauges
Tachometer Drive Removed
Oil Pan Removed
Instrument Panel-Removed
Starter Motor-Removed
Equipment
Special Tools
Condition Condition Description
Para
Chain hoist
Hammer (soft)
Generator - Removed
Studs (four)
Overspeed Governor-Removed
1/2-13 x 3 1/4 lg.
Tachometer Drive Removed
Oil Pan Removed
Flywheel Removed
Instrument Panel-Removed
Starter Motor-Removed
Material/Parts
Special Environmental Conditions
Gasket kit P/N 5193113
NONE
Personnel Required
General Safety Instructions
2
NONE
3-1609
|
||
|
||
