| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-5
3-92.2. FLYWHEEL HOUSING - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
c. Oil
Coat the lip of the seal
seal
with engine oil.
d. Pilot
Install if necessary.
studs
5. Flywheel
a. Flywheel
1. Lift with chain hoist.
housing
housing
(15)
2. Position housing over
the crankshaft and
up against the cylinder
block rear end plate
and gasket.
b. Six
Install in positions
Bolts are 3/8-
bolts
1 thru 6 (Idler gear
16. Tighten
(5) and
hub and idler gear
finger tight.
flat
hole spacer).
washers
(6)
NOTE
When tightening the idler gear hub bolts, turn the crankshaft to prevent any bind or
brinelling of the idler gear bearing. The crankshaft must be rotated for the flywheel
housing bell tightening also.
c. Pilot
Remove.
studs
d. Six
Install in positions 7
Screws are 1/2-
screws
thru 12.
13 x 3 1/4
(7) and
long. Tighten
lockwash-
finger tight.
ers (8)
e. Two
Install in positions 13
Screws are 3/8-
screws
and 14.
16 x 1 lg.
(9) and
Tighten finger
lockwash-
tight.
ers (10)
3-1614
|
||
|
||
