| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-219-14-6
3-164.2. FUEL INJECTOR TUBE - MAINTENACE INSTRUCTIONS (Continued)
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont.)
b. Spot
Remove excess stock:
facing
1. With the cylinder head
Use tool J5286-
bottom side up, insert
8.
the pilot of cutting
tool into the small
hole of the injector
tube.
2. Place a few drops of
cutting oil on the
tool. Then, using a
socket and a speed
handle, remove the
excess stock so that
the lower end of the
injector tube is from
flush to .005 inch
(0.0127 cm) below the
finished surface of
the cylinder head.
3-2761
|
||
|
||
