| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-5. MARINE GEAR MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL IN CRAFT (Cont)
6. Secure the manifold to the main housing
with sixteen 3/8-16 X 1-1/2 hex-head cap
screws (93). Tighten the cap screws to 38
lb-ft (51.5 Nm) torque. Install the three
bolts that were removed from the
propeller flange and the companion
flange.
7
Install a new corprene ring gasket (86) in
the manifold (50). Install the oil return
pipe assembly (85) in the manifold (50)
and against the gasket by indexing the
return pipe on the roll pin in the manifold
(50).
8. Place the top cover plate (14) and a new
top cover plate gasket (15) in position on
the main housing, and secure the cover
plate to the housing with ten 3/8-16 X 7/8
hex-head cap screws (13). Secure the
breather chain clip in position beneath one
of the cap screws. Tighten the cap
screws to 38 lb-ft (51.5 Nm) torque.
9. Place the oil pump assembly (49), with
attached parts and a new oil-pump-to-
manifold gasket (51) in position against
the manifold, and secure the oil pump to
the manifold with four 3/8-16 X 1 hex-
head cap screws (48). Tighten the cap
screws to 38 lb-ft (51.5 Nm) torque.
Connect the oil-sump-to-strainer flexible
hose (9) to the oil strainer housing.
10. Place the selector valve assembly (60)
with attached parts and a new selector-
valve-to-manifold gasket (61) in position
against the manifold (50) and secure the
selector valve to the manifold with two
3/8-16 X 2-3/4 hex-head cap screws (58)
and two 3/8-16 X 5-3/4 hex-head cap
screws (59). Tighten the cap screws to 38
lb-ft (51.5 Nm) torque.
5-160
|
||
|
||
