| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-7. VARIABLE SPEED MECHANICAL GOVERNER-MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-REASSEMBLY (Cont)
g. Governor
1. Lubricate bearing with engine oil.
operating
shaft
2. Start the bearing numbered side up,
lower
straight in the governor housing and
bearing
over the end of the operating shaft.
(86)
h. Governor
1. Support the governor housing and
housing
operating shaft assembly on the bed
(18) and
of an arbor press with the upper end
operating
of the operating shaft resting on a
shaft
steel support as shown.
assembly
2. Place a 7/16" inside diameter sleeve
on the inner race of the bearing and
under the ram of the press; then,
press the bearing on the shaft until
it seats on the shoulder in the
housing.
i.
Retaining
Install.
washer and
screw, and
lockwasher
(77)
j.
Expansion
1. Apply a thin coat of
Use a new plug.
plug (76)
good quality sealant
around the edge of a
new expansion plug.
2. Place the plug, con-
cave side up, in the
opening in the hous-
ing next to the
lower operating
shaft bearing.
3. Tap the center of
the plug with a
hammer to secure the
plug in the housing.
5-198
|
||
|
||
