| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-10
5-35. BLOWER - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL - ASSEMBLY (Cont)
b. Blower end
1. Support the blower
Use new oil
plates (46
end plate, finished
seals.
and 47),
surface facing up,
and oil
on wood blocks on
seals (53
the bed of an arbor
and 54)
press.
2. Start the oil seal
straight into the
bore in the end
plate with the
sealing edge facing
down (toward the
bearing bore).
3. Place the short end
of oil seal remover
and installer J6270-3
in the oil seal and
under the ram of the
press. Then, press
the oil seal into
the end plate until
the shoulder on the
installer contacts
the end plate.
NOTE
A step under the shoulder of the installer will position the oil seal approximately
.005 inch below the finished face of the end plate. This is within the .002 inch to
.008 inch specified.
4. Install the remain-
ing oil seals in the
end plates in the
same manner.
5-572
|
||
|
||
