Custom Search
 
  
 
TM 55-1905-220-14-11
5-72.
FUEL INJECTOR - MAINTENANCE INSTRUCTIONS (Continued).
LOCATION
ITEM
ACTION
REMARKS
OVERHAUL-ASSEMBLY (Cont)
3. Tighten caps to 65-75
Use 9/16 inch
lb-ft (88.1-101.7 Nm)
deep socket.
Wear protective eye goggles when using compressed air.
c. Filters
1. Purge filters after
installation by blow-
ing compressed air or
fuel thru the filter
caps.
2. Install clean shipping
caps on the filter
caps to prevent dirt
from entering the
injector.
6. Rack
and
Gear
NOTE
Note the drill spot marks on control rack and gear.
a. Injector
Hold the injector body,
body
bottom end up and slide
(12)
the rack through the
and
hole in the body.
rack
Look into the body bore
(15)
and move the rack until
you can see the drill
marks. Hold the rack in
this position.
5-1034


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business