| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-2
2-57.
RAISING BOW RAMP - LOCAL.
Local operation from winch compartment or starboard bow area. To operate the winch and raise the bow ramp,
proceed as follows:
Do not enter or attempt to move around in the winch compartment with the winch running. There
is always danger of becoming entangled in the wire rope.
Never enter the winch compartment alone.
Whenever working on the ramp gate, the wire rope, or in the vicinity of the winch in the winch
room, the power to the winch must be disconnected.
Keep clear while winch is in operation.
NOTE
Both generators should be operating in parallel.
a. Winch Compartment or Starboard bow area.
(1) Press the RAISE push-button control (1) until the ramp is against the gasket stop.
(2) Release button to stop ramp.
(3) Replace dogs on ramp and latch securely (see Illustration page 2-438).
(4) Push the "LOWER" control (2) until the ramp chain and cable are slack. The slack cable switch may shut off
the motor.
(5) Release button to stop ramp.
Change 4
2-439
|
||
|
||
