Quantcast Assembly and Installation (Cont) - TM-55-1905-220-14-40255

Custom Search
 
  
 
TM 55-1905-220-14-4
3-13. FUEL PUMP - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
Assembly and Installation (Cont)
26.
Gears and
Lubricate, using clean engine
shafts
oil.
27. Pump
Sealant
Apply an especially thin coat
Sealant must be
cover
of quality sealant to face of
very thin. Do
face,
pump cover.
not squeeze
not
sealant into
near
gear compart-
gear
ment.
area
-
28. Pump
Pump
Place cover against pump
Cover can be
body
covers
body, making sure two dowel
installed in
pins in pump cover are lo-
only one posi-
cated in holes in pump body.
tion.
29.
Pump
Install bolts and lock-
Eight bolts
covers
washers. Tighten alternately
and evenly.
30.
Pump
Rotate shaft by hand to in-
If shaft sticks,
shaft
sure that all parts rotate
tap corner of
freely.
pump. Try
again.
31. Drain
Pipe
Install.
holes
plugs
NOTE
Pump must always be installed with inlet opening in pump
cover marked "L.H.IN" next to balance weight cover.
32. Pump
Gasket
Affix new gasket to flange.
Remove all bits
body
(17)
of old gasket.
Mount-
ing
flange
33. Drive
Drive
Place fork on shaft.
shaft,
coupling
square
fork (4)
end
3-496


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.