Quantcast REMOVAL AND CLEANING (Cont) - TM-55-1905-220-14-40286

Custom Search
 
  
 
TM 55-1905-220-14-4
3-15. FUEL INJECTOR - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
REMOVAL AND CLEANING (Cont)
7. Cylinder
Injector (13)
Lift injector out
Immediately
head
of cylinder head.
after removal of
injector, cover
injector hole
to keep out dirt
or foreign par-
ticles.
Use eye protection when using compressed air.
8.
Injector
Clean exterior with
fuel oil and dry with
compressed air.
NOTE
Perform a complete engine tune-up.  However, if only one
injector was replaced and the other injectors and governor
adjustments were not disturbed, it is necessary to adjust valve
clearance and time the injector for that cylinder, and to position
the injector rack control lever.
INSTALLATION OF INJECTOR
9. Injector
Injector
Insert into tube.
Make sure
tube
dowel pin
(14) in in-
jector body
registers
with locating
hole in cy-
linder head.
3-528


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.