| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-5
3-89.1. CYLINDER HEAD-MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
e. Injec-
1. Set the injector con-
tor
trol tube assembly in
control
place on the cylinder
tube
head and install the
assem-
attaching bolts finger
bly
tight. When position-
ing the control tube, be
sure the ball end of each
injector rack control lever
engages the slot in the cor-
responding injector control
rack. With one end of the
control tube, return the spring
hooked around an injector rack con-
trol lever and the other end
hooked around a control tube
bracket. Tighten the bracket
bolts to 10-12 lb-ft 14-16 Nm)
2. After tightening the bolts, revolve
the injector control tube to be
sure the return spring pulls the in-
jector racks out (no-fuel position)
after they have been moved all
the way in (full-fuel position),
since the injector control tube
is mounted in self-aligning
bearings, tapping the tube
lightly will remove any bind
that may exist. The injector
racks must return to the no-
fuel position freely by aid of
the return spring only. Do not
bend the spring. If necessary,
replace the spring.
3-1476
|
||
|
||
