| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-5
3-96.4. CYLINDER LINER - MAINTENANCE INSTRUCTIONS (Cont).
LOCATION
ITEM
ACTION
REMARKS
INSTALLATION (Cont)
d. Lower
Assemble and lubricate.
The lower bear-
bearing
ing shell has a
shell (4)
continuous oil
and bear-
groove from one
ing cap
parting line to
(5)
the other. Lu-
bricate the
bearing shell
with clean en-
gine oil.
e. Bearing
Install the bearing cap
Tighten the
cap with
and the bearing shell on
connecting rod
bearing
the connecting rod with
bolt nuts to
shell,
the identification num-
60-70 lb-ft
connec-
bers on the cap and the
(81-95 Nm)
ting rod
rod adjacent to each
torque (notch
(2), nuts
other.
or imbedded "0"
(6), and
lubrite nut) to
bolts (1)
65-75 lb-ft
(88-102 Nm)
torque (castel-
lated nut).
f.
Connec-
Check the connecting rod
The clearance
ting rod
side clearance.
between each
(2)
pair of connec-
ting rods
should be .008
to .016 inch
(0.020 to 0.041
cm) with new
parts.
NOTES
1. Install the remaining liner, piston and rod
assemblies in the same manner. Use hold-down clamps
to hold each liner in place.
2. After all of the liners and pistons have been
installed, remove the hold-down clamps.
3-1690
|
||
|
||
