| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-8
4-5. GENERAL (Continued).
Table 4-22. Washer/Dryer Troubleshooting.
NOTE
Refer to paragraph 4-42 for maintenance instructions.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. No product operation.
Lack of power.
Check circuit breaker.
Check for proper service cord connections.
2. No operation - washer unit only.
Step 1. Lid switch.
Check operation of lid switch and continuity
through the switch.
Check switch contact arm (lid hinge pin) for
to activate switch when closed.
Step 2. Timer.
Check operation of timer knob and dial assembly
(push-pull switch).
Step 3. Motor overload protector.
Protector should automatically reset after several
minutes. Check for cause of overload, bind in
mechanism or clutch. If not, replace motor.
Step 4. Washer motor capacitor.
Check motor capacitor.
3. Washer vibration during spin or agitation.
Step 1. Unbalanced load product not properly leveled.
Readjust load and re-spin.
Re-level product side to side and front to back.
4-67
|
||
|
||
