| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-8
4-5. GENERAL (Continued).
Table 4-22. Washer/Dryer Troubleshooting (Continued.)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
8. Overfill.
Step 1 . Pressure too great in water supply system.
Check flowing water pressure at product to be
below 120 psi (825.5 kPa). Reduce flowing
pressure by partially closing supply faucets.
Step 2. Damaged or improper flow washer.
Replace flow washer as necessary.
9. Water leaking onto deck.
Step 1. Overfill - water valve or timer malfunction and
water level safety switch inoperative.
Check water level safety switch for operation with
outer tub 1/3 to 1/2 full. Check fill period for
proper timer sequencing and water valve operation.
With continuous fill, disconnect electric supply
and observe the action. If water fill stops,
trouble is indicated in timer or electrical
connections. If water fill continues, trouble is
indicated in water valve. Repair or replace as
necessary.
Step 2. Water thrown out over top.
Check spin acceleration. If spin clutch torque is
too high, water can be spun out over top of tub.
Step 3 . Leak at seal between outer tub and sub-top.
Remove sub-top and adjust seal between sub-top and
outer tub.
Step 4. Leak at pump seal or tub shaft seal.
Check for source of water and reinstall new seal as necessary.
4-71
|
||
|
||
