| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-220-14-8
4-5. GENERAL (Continued).
Table 4-22. Washer/Dryer Troubleshooting (Continued.)
MALFUNCT1ON
TEST OR INSPECTION
CORRECTIVE ACTION
Step 7. Faulty water temperature selector switch.
Check the selector switch and replace as necessary.
Step 8. Inoperative hot water solenoid on the water valve.
Replace the solenoid.
Step 9. Dirty or damaged plunger or diaphragm on the hot side of the water valve.
Clean or replace the diaphragm and plunger.
11. Clothing too wet after final spin.
Step 1 Drain is restricted causing outer tub to fill
sufficiently to restrict speed of agi-tub.
Correct cause of drain restriction.
Check pump cover gasket to be properly in place.
Step 2. Improper spin speed.
Check as for NO SPIN.
12. Odor in washer unit.
Step 1 . Soap scum accumulation on walls and bottom of outer
tub from use of soap in hard water.
Remove sub-top from outer tub and use stiff brush
to remove scum. Dissolve one pound of Calgon
during FILL period. Permit Calgon water to spin
into outer tub and stop the washer. Allow to sit
for one hour, then place washer into final rinse
and permit washer to finish complete cycle.
13. Torn clothing.
Step 1. Improper use of bleach.
Review with user the proper use of bleach in the washer.
4-73
|
||
|
||
