| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-29. ENGINE SPEED GOVERNOR (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
g. Place bearing (52) over
end of shaft (49).
h. Support opposite end of
Use a sleeve
shaft on bed of a press,
which has the
and press bearing (52) on
same diameter
the shaft against washer
as bearing
(53).
inner race.
i.
lace bellcrank (51) over
end of shaft with pin (57)
up with flat on shaft reg-
istering with flat surface
in bellcrank.
j.
Press bellcrank onto shaft
(49) tight against bearing
(52).
k. Lubricate bearing (52) on
shaft and bushing (54) in
governor shaft fork (50) with
clean engine oil.
1. Insert bellcrank and shaft
into housing (27).
m. Position governor shaft fork
(50) over lower end of shaft
so finished side of fork will
rest against thrust bearing
when governor is assembled.
n. Support the operating shaft
and control housing (27) in
an arbor press with the upper
end of the operating shaft
resting on a steel block.
Align the flat in the fork
(50) with the flat on the
operating shaft. Then, place
a sleeve over the end of the
shaft, and rest it on the
fork. Bring the ram of
5-532
|
||
|
||
