| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-2
5-29. ENGINE SPEED GOVERNOR (Continued).
LOCATION/ITEM
ACTION
REMARKS
ASSEMBLY (Cont)
l.
Support the lower end of
throttle shaft on the bed of
arbor press. Then, place a
sleeve on throttle lever and
under ram of press. Align
the slot in cam with pin in
throttle lever; then press
the lever down on the shaft
until hole in the lever is
in line with the hole in the
shaft.
m.
Insert straight pin (12) in
the hole of the lever. Support
the lever and cover assembly on
a steel block and drive the pin
into place.
n.
Position speed control lever
Install lock-
(11) on throttle shaft (8),
washer (10), and
and tighten capscrew (9).
capscrew (9), if
removed.
o.
Install plug (7) in throttle
shaft.
10.
Governor
a.
Assemble weight housing (25),
gasket (26), and control
housing (27).
b.
Install gasket (24), weight
housing cover (23) using screws
(21) and lockwashers (22).
c.
Install gasket (6) and cover
(5) assembled on control
housing (27).
d.
Install three screws (3) and
lockwashers (4).
e.
Install special screw (2) and
spring (1).
5-538
|
||
|
||
