| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-3
6-23.3.
CAMSHAFT AND BALANCE SHAFT - MAINTENANCE INSTRUCTIONS.
(Continued).
LOCATION/ITEM
ACTION
REMARKS
REMOVAL - FLYWHEEL HOUSING AND MARINE GEAR REMOVED (Cont)
NOTE
If the thrust washers (11), located between the
bearings and thrust sh ulders at the front end of
o
the shafts on the "B" engines are not removed with
the shafts, they should be pulled out when removing
the bearings, proceed to step j.
j.
The camshaft front bearings (12)
(and thrust washers "B" engines)
may be removed after taking out
the screws (13), and lockwashers
(14) that hold the bearings to the
end plate and cylinder block. Pry
under the bearing flange with a
suitable tool if the bearing
cannot be withdrawn by hand.
NOTE
On the "D" engine the rear bearing (15) and thrust
washers (16) are removed when the shaft and gear
assembly is removed.
6-337
|
||
|
||
