| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-35. BLOWER ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
36. Front End
a. Support front end plate (90),
Plate, Oil
finished surface facing up, on
Seals, and
wood blocks on bed of an arbor
Pins
press.
NOTE
If oversize oil seals are being used in end plates, use installer J1682-13 to install oversize
spacers on the rotor shafts.
b. Start oil seals (96) straight
into bore in end plate with
sealing edge facing down
(toward bearing bore).
c. Place the short end of the oil
seal remover and installer
J6270-3 in the oil seal and
under the ram of the press.
Then, press the oil seal (96)
into the end plate until the
shoulder on the installer
contacts the end plate.
NOTE
A step under the shoulder of the installer will position the oil seal approximately .005 inch below
the finished face of the end plate. This is within the .002 inch to .008 inch specified.
6-668
|
||
|
||
