| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-35. BLOWER ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
(2)
Place the blower housing
(92) on a bench with the top
of the housing up, and the
front end of the housing
facing the outside of the
bench.
(3)
Position the end plate in
Note that gas-
front of the blower housing
kets are not
with the flat finished face
used between
of the end plate facing the
the housing;
housing and the end marked
therefore, the
TOP facing the flanged side
mating surfaces
of the housing. Then, start
must be flat
the dowel pins (93) straight
and smooth.
into the dowel pin holes in
the housing. Push or tap
the end plate (90) against
the housing.
(4)
Insert the two fillister
head screws (89) through the
end plate and thread them
into the housing. Tighten
the screws securely. Do not
use lockwashers on these
screws.
6-670
|
||
|
||
