| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-37. POWER TAKE-OFF ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
b. If removed, lubricate the
outside diameter of the
outer roller bearing (9)
cup, with engine oil.
Then start it straight
into the bearing bore in
the clutch housing with
the tapered inner diameter
of the cup facing up.
c. Place a (1" O.D. x 15"
long) hard wood block on
the top edge of the
bearing cup, then use a
hammer, to tap the
bearing cup down in the
clutch housing by tapping
it alternately at several
places.
CAUTION
Be careful not to get any wood chips off of the wood block under the bearing cup.
d. Support the clutch
housing (10) on wood
blocks in a horizontal
position.
e. Lubricate the roller
bearing cones (46) with
light engine oil. Then
insert the outer end of
the clutch drive shaft
(6) through the bearing
bore from the forward
side of the clutch housing
until the bearing cone
contacts the bearing cup.
6-769
|
||
|
||
