| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-37. POWER TAKE-OFF ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY - CONTINUED (Cont)
CAUTION
The clutch release sleeve is a close fit on the drive shaft and must be started straight over the
clutch drive shaft to prevent any bind between the release sleeve and the drive shaft.
c. Slide the clutch assembly
back on the clutch drive
shaft (6) until it is
tight against the taper
on the drive shaft.
Then insert the key (60)
in the keyway and tap it
into place with a punch
and a hammer.
d. Place the lockwasher
(34) on the drive shaft
and against the outer
pressure plate with the
tang on the inner diameter
of the lockwasher in the
keyway in the pressure
plate.
e. Install clutch drive
shaft nut (17).
f. Install the key in the
keyway of the clutch
drive shaft. Attach a
chain wrench to the
drive shaft to prevent
the drive shaft from
turning.
6-779
|
||
|
||
