| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
DISASSEMBLY (Cont)
v. Remove the oil seal (15) from
the power driven shaft
bearing retainer (16) as
follows:
If inspection reveals the lip
of oil seal is rough or
charred, it may be removed as
outlined below:
1.
Support the driven shaft
bearing retainer on two
steel supports on the bed
of an arbor press, spaced
far enough apart to permit
the removal of the oil
seal, with the rear face
of the retainer up, as
shown below.
2.
Place tool J3154-04 with
suitable plates on top of
the oil seal and under ram
of press, then press the
oil seal out of the
bearing retainer.
6-805
|
||
|
||
