| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-221-14-4
6-38. TRANSFER GEAR ASSEMBLY (Continued).
LOCATION/ITEM
ACTION
REMARKS
REASSEMBLY (Cont)
2.
Position the drive gear
with bearings over one of
the openings in the gear
housing with the long
protruding end of the gear
hub down.
3.
Lower the drive gear
straight down and mesh the
teeth of drive gear with
the driven gear. Then,
start the bearing straight
into the bearing bore of
gear housing. Push or tap
the gear and bearing into
the gear housing until the
bearing seats squarely in
the counterbore of the
bearing cover.
4.
Install the second drive
gear and bearing assembly
in the opposite opening of
the gear housing in the
same manner as described
above.
q. Support the transfer gear
housing on suitable wood
blocks with the power driven
shaft in a horizontal posi-
tion.
r. Tighten the power driven gear
locknut (12) and drive flange
retaining nut (18) as follows:
1.
Wedge a clean cloth
between the gear teeth to
prevent the power driven
shaft from turning.
6-818
|
||
|
||
