| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
5-22
REPLACE RAMP WINCH HYDRAULIC MOTOR (Continued).
g.
Install spring cover (1) over the
motor assembly (3) so that the vent
port is located in the correct
position as required.
h.
Install capscrews (4) and seal
washers (5). Tighten evenly making
sure that the spring cover (1)
remains parallel to the end of the
primary housing as it is tightened into
place. Torque the capscrews to 50
pounds foot.
5-23
REPAIR RAMP WINCH HYDRAULIC MOTOR.
This task covers:
a.
Disassembly
c. Inspection
b.
Cleaning
d. Assembly
INITIAL SETUP
Tools:
Equipment Conditions:
Tool Kit, Mechanic's Rail
References
and Marine
Bearing Puller
Materials/Parts:
Materials/Parts:
Cleaning Solvent
Backup Washer
Item 17, Appendix E
P/N 50362 (2)
Grease
Backup Washer
Item 2, Appendix E
P/N 50487 (4)
'O' Ring
Backup Washer
P/N 50306 (2)
P/N 50368
'O' Ring
Backup Washer
P/N 50488 (2)
P/N 50367
'O' Ring
Medium Pocket Seal
P/N 50332 (2)
P/N 50485 (4)
'O' Ring
Large Pocket Seal
P/N 50339
P/N 50486 (8)
'O' Ring
Small Pocket Seal
P/N 50337
P/N 50484 (8)
5-54
|
||
|
||
