| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-10
REPAIR RAMP WINCH (Continued).
d. Install pin (57) and, using 3/16" diameter pin
punch, drive the pin in until the outer end of
the pin is 7/16" below the outside diameter of
the final planet hub (59).
e. Repeat the above for the remaining two final
planet gears (60) and check that all the gears
run freely.
2. ASSEMBLE PRIMARY PLANET
ASSEMBLY.
a. Lubricate 'O' ring (56) and install its groove in
the thrust pad (55). Give 'O' ring an additional
coat of grease and install the thrust pad (55) in
its recess in the inside wall of the primary planet
hub (45) so that the slotted face of the thrust
pad is outward.
b. Press the thrust plugs (47) into the ends of the
primary planet pins (46).
6-50
|
||
|
||
