| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-222-14
6-10
REPAIR RAMP WINCH (Continued).
h.
Install the segments (18) in the groove next
to the internal teeth in the primary housing
(19). Make sure thinnest side of groove is next
to the brake piston.
i.
Install the retainer (17) in the groove formed
on the inside of the segments (18) so that the
ends of the retainer (17) rest in center of one of
the segments.
j.
Install the primary sun gear (15) in the primary
planet assembly (16) so that the teeth on
the outside diameter engage with the gears in
the primary planet assembly.
NOTE
FOLLOW-ON MAINTENANCE:
Install motor assembly (para. 5-22).
6.
INSTALL DRUM ASSEMBLY, FINAL HOUSING
AND PRIMARY HOUSING ON WINCH BASE.
a.
Place the winch base (41) on a work bench so
that the final drive side is facing up.
b.
Attach the final housing (3 ) to the winch base
(41) using seven dowel bolts (4), lockwashers
(2) and nuts (1).
c.
Turn the assembly over so that it rests on
the end of the final housing.
d.
Install the drum assembly and pilot the bearing
on the splined end of the drum into the bore of
the final housing (3).
6-58
|
||
|
||
