e. Use a mallet to connect manifolds (1, 9, and 10).
The manifold sections must be on a level surface when
tightening the capscrews. If the portion of the manifold that
touches the cylinder heads is not in alignment, exhaust
leaks will result.
f. Put manifold on a level surface. Ensure that the portion of the manifold that touches the cylinders
(exhaust ports) is touching the level surface. Use a mallet to tu n the manifold sections until all of the
exhaust ports are in alignment.
g. Install lockwashers (4) and hexagon head capscrews (3). Tighten capscrews to 35 ft-lb (45 Nm)
h. Position gaskets (5) with bolt holes aligned.
i. Position water transfer connections (6), on gaskets (5), with bolt holes aligned.
j. Install hexagon head capscrews (8) and lockwashers (7). Tighten to 35 ft-lb (45 Nm).
k. Replace the exhaust manifold group, paragraph 2-33 .