| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-1
CAUTION
Do not rotate the crankshaft until the main bearing caps are pulled to the block.
Damage will result if the bearings move out of location.
j.
Turn the crankshaft by hand to check ease of movement. If it does not turn, remove main bearing caps
one at a time and recheck ease of movement. This will locate the out-of-alignment cap.
k.
Lubricate washers (2, FIG. 4-47) and heads and threads of side bolts (1). Install wasers and side
h
bolts. Do not tighten.
l.
Torque main bearing capscrews (3, FIG. 4-58) using the procedure in Table 4-5 and the sequence
in FIG. 4-59.
FIGURE 4-59. Main Bearing Capscrew Torquing.
m.
Repeat step j.
n.
Torque the side bolts (1, FIG. 4-47) using the procedure in Table 4-6 and the sequence in FIG.
FIGURE 4-60. Side Bolt Torquing.
4-54
|
||
|
||
