| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-16
q. Position preformed packing (26 and 28), plate (27), and dowel pins (25) between stators (18) and (29). Ensure
that dowel pins are installed as noted during disassembly.
r.
Align stators (18 and 29) with plate (27) dowel pins (25) and engage both stators. Ensure proper orientation as
observed during disassembly.
s.
Position preformed packing (17), plate (16), dowel pins (12) on stator (18). Ensure that dowel pins are installed as
noted during disassembly.
t.
Secure preformed packing (17) and plate (16) to stator (18) with machine screws (15).
u. Replace ball bearings (13) on front housing (11) as noted during disassembly.
v.
Position preformed packing (14) between plate (16) and front housing (11).
w. Align front housing (11) preformed packing (14) assembled stators (18 and 29) with rear housing assembly (43).
Ensure proper orientation as observed during disassembly.
x.
Install retaining bolts (10), but do not tighten.
y.
Press bearing (8) onto shaft (9).
NOTE
A rocking motion of shaft may be necessary to allow shaft alignment with stators and front and rear
housing assemblies.
z.
Insert shaft (9) through front housing (11) stators (18 and 29) and engage with roller bearing (42) in rear housing
(43).
aa. Press bearing (8) into front housing (11).
ab. Install retaining ring (7), preformed packing (6), seal plate (5), preformed packings (3 and 4), and retaining ring (2).
ac. Secure motor assembly with retaining bolts (10).
CAUTION
To prevent possible damage to internal parts, hydraulic motor assembly should never be operated dry or
without internal lubrication.
ad. Fill hydraulic motor assembly with hydraulic fluid through ports on rear housing. Rotate shaft to ensure that
internal moving parts are lubricated; then, drain hydraulic fluid from motor.
4-60
|
||
|
||
