| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-1
a.
Ensure retainer nut (9) is installed on outer tub.
b.
Install flinger (8), bearing housing assembly (7), and washer (6) with
hexagon head capscrew (4) and lockwasher (5).
c.
Install balance ring (3) on mechanical transmission (10).
NOTE
The mark located on the outer edge of the
balance ring indicates the heavy side of the
balance ring. This heavy side must be
installed opposite the rack area of the
transmission.
Install lockwasher (2) and hexagon head capscrew (1).
d.
e.
Install bearing (2, FIGURE 2-71) in bearing housing assembly (1).
Install bearing housing assembly on transmission.
f.
Install brake pad (22), sleeve (21), and shoulder screw (20).
g.
h.
Install spacer (3).
i.
Install brake assembly (19).
NOTE
When reinstalling helical compression
spring, be sure it is inserted into groove
in large spline of transmission tube.
Install helical compression spring (4), flat washer (5), retainer and roller
j.
bearing (6), and outer bearing rings (18, 17).
Install groove pulley (16) on transmission.
k.
Install helix (15), flat washer (14) and machine screw (13).
l.
m.
Install leg (7) on bearing housing assembly (1) with lockwasher (8) and
hexagon capscrew (9).
n.
Install pivot dome (12) on leg (7) with lockwasher (10) and hexagon capscrew
(11).
CAUTION
Carefully lower transmission through upper
bearing and flinger. Do not drop or lower
transmission into position too hard.
2-375
|
||
|
||
