| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-18-2
b. Disassemble fixed window assembly as follows:
(1) Remove glazing gasket (18) from window frame (15).
(2) Carefully remove (heat treated) window glass (17) from window frame.
NOTE
If window glass is to be replaced disregard the following step.
(3) Clean off old rubber strip (16) from window gIass (17).
REPAIR
Repair at this level of maintenance is by replacement of: sealing tape(4), adhesive sealant (5), glazing
gasket (18), (heat treated) window glass (17), rubber strip (16), junction box (5), fixed glass (7), d.c. motor (10),
motor brushes (9), cable feed tube (12), defroster/heater (1), rotating glass (12), and gasket (3).
ASSEMBLY
WARNING
Care must be taken while handling windows to prevent personal injury or equipment damage.
a. Assemble fixed window assembly as follows:
(1) Install rubber strip (16) on window glass (17).
(2) Carefully install (heat treated) window glass (17) in window frame (15).
(3) Insert glazing gasket (18) in window frame.
b. Assemble rotary window assembly as follows:
(1) Install defroster/heater (1) in frame ring (2).
(2) Install gasket (3) around frame ring (2).
(3) Position frame ring (2) in fixed window assembly.
(4) Install retaining ring (4), junction box (5), and secure using screws (11).
(5) Install cable feed tube (14) in motor (10).
(6) Install back plate on motor (10).
(7) Inspect drain holes at the bottom of the frame ring (2) for obstructions prior to installing glass.
(8) Clear drain holes as necessary.
3-618
|
||
|
||
