| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
e. Connect the exhaust piping.
f. Install the coolant heater, if removed.
g. Connect oil pressure sensor switch supply line.
h. Connect water inlet and outlet tubes.
i. Connect the coolant heater (paragraph 2-42).
j. Install inlet connection on the fuel filter assembly (paragraph 2-33).
k. Connect all external electrical wiring to the instrument panel, fuel pump, and remote sending units.
1. Connect air supply lines to air starter, port engine (paragraph 2-24).
m. Connect electrical wiring and cables to electric starter, starboard engine (paragraph 2-25).
n. Close the following valves:
(1) Fuel drain.
(2) Oil drain.
(3) Coolant drain.
o. Open the following external valves:
(1) Coolant supply.
(2) Coolant vent.
(3) Oil supply.
(4) Air supply (port engine).
(5) Fuel supply.
p. Install generator (paragraph 3-13).
NOTE
Replace any external components or fixtures that were moved, or removed, to
facilitate removing the old engine assembly.
q. Perform break-in, pre-servicing, start-up, run-checks, and generator inspection in accordance with
3-33
|
||
|
||
