| Tweet |
Custom Search
|
|
|
||
 TM 55-1905-223-24-3
h. Install the accessory drive seal (1, Figure 3-38) as follows:
(1)
Install the oil seal on P/N ST-1173 Fuel Pump Drive Oil Seal Mandrel with the part number side
facing the driver.
CAUTION
Do not use any kind of lubricant to install the seal. The oil seal must be installed
with the lip of the seal and the seal wear area of the accessory drive pulley clean
and dry. Use of lubricant will result in oil leakage at the seal.
(2)
Put fuel pump drive oil seal mandrel over the accessory drive shaft.
(3)
Align the keyway in the driver with the groove pin in the accessory drive shaft.
(4)
Push the seal into the seal bore until the seal casing fits against the ledge.
i.
Install the dowel pin (if removed) in the accessory drive shaft (Figure 3-37).
j.
Install the accessory drive pulley (paragraph 3-19).
k.
Install the water pump belt (paragraph 2-33).
1. Install the four capscrews that hold the oil pan to the gear cover (1 through 4, Figure 3-43).
m. Tighten two 7/16 inch oil pan mounting capscrews (11 and 25) one on each side of the oil pan, halfway
between the front and the rear of the oil pan, to 15 ft-lb (20 N ) torque.
M
n. Tighten the four 5/16 inch capscrews in the rear of the oil pan to 20 ft-lb (25 N ) torque in the
M
sequence shown in Figure 3-43.
o. Tighten the 32 7/16 inch capscrews to 50 ft-lb (70 N ) torque in the sequence shown in Figue 3-43.
M
p. Fill the lubricating oil system (PMCS Table 2-1, Item 15).
q. Connect battery banks (starboard), operate air system (port), refer to TM 55-1905-223-10.
r.
Run the engine until it reaches a temperature of 180 (80 ) and check for leaks.
F
C
3-83
|
||
|
||
